serviceMACHINE MAINTENANCE AND SAFETY

Maintenance of Mobile Machining Service and Fittings is important thing. It all process done so that a condition of machinery and equipment used can be durable and long lasting. There are many things relating to the maintenance of machinery and equipment namely:

  • Clean the machine will be used during and upon completion work.
  • Check condition of the buttons on the machine is functioning properly.
  • Check function and inhalation of dust or cooling pump is working properly.
  • Check lights are functioning properly.
  • When used machine table must be closed.
  • Tightening well just lock
  • Apply the oil on the open and easy to rust
  • Keep tools are not used and lubricate with oil.

By using flat Mobile Machining Service grinding stone wheels, corners cut on the cutter side will be zero. Here are the steps that must be implemented:

  • Install the cutter on the appropriate and mounted on the main shaft.
  • Set the corners that showed zero on the scale, position the cutter perpendicular to the grindstone.
  • Set the height of the grinding stone (no.11) to the center with a cutter.
  • Set the stopper such that the surface of the grinding stone cutter exactly half its diameter.
  • Remove the pin so as to rotate the handle freely.
  • Ingestion motion by rotated handle to the surface of flat cutter.

 

Milling Cutter cutting edge:

By using the grinding stone cup wheels, corners cut on the side of the cutter will be reshaped.

  • Note: note the number of eye-piece on the cutter
  • Adjust the angle to form an angle
  • Adjust the height of the grinding stone to the center with a cutter.
  • Set the stopper induce motion funeral reach the center line on the cutter.
  • Exercising feeds by turning the handle while moving the handle left and right, so that the surface of the cutting edge honed all.
  • After reaching a certain burial depth on the scale, loose pin and rotate scale in accordance with the number of eye-piece on the cutter.
  • Repeat steps 4, until all sides of the piece honed all.
  • Back adjust the angle, and repeat step No.3-6.
  • To check whether the eye pulled cutter has honed well and have the same height with one another, use a block with a flat surface, and place the cutter perpendicular to the surface of the field.